Note about the maintenance tank: Instead of replacing a full maintenance tank, you may use a chip resetter to reset your maintenance tank chip to read empty, and reuse the tank many times. Important Note: In order to run an initial fill cycle, your new cartridges must each be at least 30% full. If they are less than 30% full, the printer will not allow you to continue until you replace those cartridges determined to be too empty to proceed. Once beginning an initial fill cycle, there is no way to abort it, and so your printer will be waiting for you to replace those cartridges it instructs you to install. If your Piezography cartridges are new, they will be full, but if they have been used in the past, removed, and you are now in the process of reinstalling them, you need to know how full they are before you go forward with the procedure. If you are not sure how full your Piezography cartridges are, install them and turn the printer on normally. The ink status monitor will display the ink levels.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |